Difference between revisions of "Windows beheerde werkplek"
m |
m (→[nl]Software[/nl][en]Software[/en]) |
||
Line 136: | Line 136: | ||
[/nl] | [/nl] | ||
[en] | [en] | ||
− | There is a [Microsoft_windows|list of Windows software]] that is or can be installed on C&CZ managed PCs. | + | There is a [[Microsoft_windows|list of Windows software]] that is or can be installed on C&CZ managed PCs. |
[/en] | [/en] |
Revision as of 18:07, 2 October 2015
Contents
General
The 'Managed PC' is a standard Windows machine which gets installed with standard software. The installation of the PC runs fully automated without any user interaction. When such a 'Managed PC' gets installed an employee of C&CZ needs approximately 5 minutes to start the installation and to enter some initial data. Thereafter the installation runs fully automated and will be finished after approximately 1 hour. At this moment the freshly installed PC needs to be added by C&CZ to 'Prism & Deploy' by hand. After a reboot the rest of the software is automatically installed. What that rest of the software exactly is, depends also on the group to which the PC belongs. For a list see below.
Capabilities
Because the needs differ for employees and departments within the Faculty of Science, there are different kind of 'Managed PCs':
Fully managed PC
[Show/hide]
Department contact managed PC
[Show/hide]
User managed PC
[Show/hide]
Installed PC
[Show/hide]
Hardware requirements
The minimal requirements for a new installation of a "Managed PC" are now (end of 2013):
- Owned by Radboud University (because of software licenses)
- Not older than 5 or 6 years
- A network card or onboard network interface with PXE
- Processor 64-bit and at least dual core
- 4 GB memory
- 160 GB harddisk for single boot and 250 Gigabyte harddisk for dual boot
- No additional expansion cards for network, graphics, audio, etc.
The standard RU PC (HP Compaq Elite 8000 series and dc7800/dc7900) and standard RU laptop (HP Probook) that has the above properties, suffices.
Peripheral hardware
Connecting peripheral hardware to a 'Managed PC' can run into problems. Especially if the new hardware requires installation of special software or drivers. As a 'unprivileged' user one does not have the rights to install such software. In this case a solution could be to change the PC into a 'Department managed PC' or a 'User managed PC' (this has impact on support available from C&CZ).
Software
There is a list of Windows software that is or can be installed on C&CZ managed PCs.